Glossary; Important Safeguards And Warnings; General Information - SINTERIT LISA X Original User Manual

1.4 Glossary

The following terms and forms have been adopted and used in the manual.
• Print Bed – a chamber where the powder is sintered and where the 3D model is created.
• Feed Bed – a chamber that stores new, unsintered powder. From this chamber, the powder is taken layer by layer into
the Print Bed.
• Overflow Bin – a chamber used to collect the excess unsintered powder, transferred from the Feed Bed to the Print
Bed by the Recoater.
• Recoater – a tool in the form of a roller, moving on a guide bar. Transfers the powder from the Feed Bed to the Print
Bed during the printing process.
• Cake – contents of the Print Bed after printing is complete. It consists of the printed model and the unbaked powder
around the model.
• IO Box – In & Out BOX, a tool designed to pull the cake out of a Print Bed.
• Flight case – a special case used to ship the printer.

2. IMPORTANT SAFEGUARDS AND WARNINGS

2.1 General information

WARNING!
The following indications are, by themselves, not enough to fully protect against all the hazards
that could arise during printer operation. These will have to be integrated with common sense and
the experience of the operator, both of which are crucial factors for preventing accidents. Each
section of this manual lists further specific safety warnings for the various operations.
WARNING!
If anything during the printer operation concerns you, press the E-STOP button and contact our
After Sales team: support@sinterit.com.
WARNING!
• To ensure the safe use of the Sinterit Lisa X 3D printer, please read and follow the instructions
below.
• Always keep the user manual within reach on the device. Keep it for future use.
• All warnings and instructions on the product should also be followed.
• Unless these messages are heeded, operator injuries or device damage could occur.
WARNING!
• The device should be installed in accordance with this manual and only by trained personnel.
• The device may only be safely used or operated by adults and can pose serious risks to
children.
STOP!
Risk of injury!
• Do not tilt the machine! The operator may be crushed.
• Climbing on the Lisa X device is forbidden.
• Do not lean on the device.
STOP!
• It is prohibited to remove covers/walls of the machine.
• It is prohibited to reach inside the machine through process openings.
• It is prohibited to bypass technical protection measures (e.g. E-STOP).
Sinterit Lisa X SLS 3D Printer Original User Manual | 7