Remove Material - SINTERIT LISA X Original User Manual

10. REMOVE MATERIAL

Whenever you decide to change the type of powder you are using, you must first thoroughly clean the printer, in order to
avoid cross contamination.
ATTENTION!
Specialty powders, in particular the PA11 CF (Carbon Fiber) and PA11 ESD powders, should be
gently cleaned with cloth only, without using compressed air. See recommendations and warnings
in Chapter 2.7.1 Working with hazardous and potentially hazardous powders.
ATTENTION!
• Treat any cleaning consumables contaminated with powder as industrial waste.
• Consult the Safety Data Sheets (SDS) of specialty materials for information on proper disposal.
1. To start press the MAINTENANCE button on the screen.
2. Next to find nad press REMOVE MATERIAL.
3. The printer will also detect whenever you try to start printing with a powder different from the last used one, and
prompt you to remove the material (fig. 10.1).
4. Press UNLOCK LID on the screen to release the electrolock and allow the printer to be opened. Remember, you only
have 10 seconds to open it before the lock activates again.
5. Push on the lid and pull it up using the handle (fig. 10.2).
6. Check for miscellaneous items and obstructions in the printer chamber. Afterwards press POSITION. Recoater will
automatically position itself over the Print Bed.
7. Using a 2 [mm] allen key, unscrew both screws on the Recoater cover and take it off (fig. 10.3).
8. Gently remove the black cover from Recoater (fig. 10.4).
To use a different material, remove the current one.
PRINTING
The printer is currently filled with PA12.
CANCEL
Fig. 10.1 The printer automatically detects a change of material.
Fig. 10.2 Lifting the printer lid.
REMOVE MATERIAL
Sinterit Lisa X SLS 3D Printer Original User Manual | 37