Unpacking Lisa X - SINTERIT LISA X Original User Manual

4. UNPACKING LISA X

WARNING!
The device weighs approx. 150 [kg]. Two adults will be needed to unpack the Lisa X printer properly
and safely.
WARNING!
When driving the printer down/up the gangway, check carefully that the wheels are in the guides.
IMPORTANT
During installation, watch out for metal edges and glass parts of the device and
flight case. Wear protective gloves.
IMPORTANT!
Please make sure that the printer was not damaged during shipping. In case of any issues or
questions, please contact technical support: support@sinterit.com
Two people
1. Cut through the protective foil covering the flight case.
2. Unlock the locks on the flight case door (4 pcs.). Lift the lock handle up to a perpendicular position, then turn it
clockwise.
3. Take the flight case cover off.
4. Lift the gangway support and lower the gangway.
5. Take out the power cable from under the printer. If present, remove the box with spare Recoater cords/strips from the
left side of the printer (optional, depending on order).
6. Unlock the wheels (there are 2 locks).
7. Slide the printer out of the flight case. Guides were installed on the gangway for a comfortable and safe descent. This
step requires the help of another person.
8. Place the printer in its desired location, then lock the wheels.
For easy and safe unpacking you will need:
Protective gloves Utility knife
Sinterit Lisa X SLS 3D Printer Original User Manual | 20