Cleaning The Pyrometer Window - SINTERIT LISA X Original User Manual

ATTENTION!
Maintenance must always be performed by qualified technicians who are trained in the tasks they
perform.
ATTENTION!
Remember to perform regular machine maintenance. Exceeding the time indicated by the counters
can have a negative effect on the quality of printouts and even cause damage to the machine.
ATTENTION!
Before performing any maintenance:
• make sure you have carefully read the directions in this manual and know how the printer
works,
• make sure that no unauthorised persons remain in the work area,
• make sure the necessary tools are available and that they are in a good condition,
• make sure there is sufficient lighting, and if necessary, provide portable 24-volt lamps.
Use of unsuitable tools or tools in poor condition can cause serious damage.
ATTENTION!
Before performing any maintenance work, always wear appropriate protective clothing, protective
glasses, facemask and gloves, appropriate to the type of work being performed.
IMPORTANT!
If you have any questions, please contact our After Sales team. For more information, please visit
our website: www.sinterit.com/support/contact-support/.

13.2 Cleaning the pyrometer window

You will need: 2 x cotton cloth, ethanol-based cleaning solution.
1. Choose UNLOCK LID on the printer screen.
2. Push on the lid and pull it up using the lid handle.
IMPORTANT!
After 10 seconds the electrolock will reactivate and it will no longer be possible to lift the lid. If you
still want to open the printer, slide the UNLOCK LID button again on the printer screen.
Sinterit Lisa X SLS 3D Printer Original User Manual | 45