Starting The D-Link Embedded Web Interface - D-Link Web Smart DES-3252P Install Manual

Starting the D-Link Embedded Web Interface

Notes
• Disable the popup blocker before beginning device configuration using the EWS.
This section contains information on starting the D-Link Embedded Web interface. To access the D-Link user
interface:
1. Open an Internet browser.
2. Ensure that pop-up blockers are disabled. If pop-up blockers are enable, edit, add, and device information
messages may not open.
3. Enter the device IP address in the address bar and press Enter. The Enter Network Password Page opens:
Figure 11: Enter Network Password Page
4. Enter your user name and password.
Notes
• The device is configured with a user name that is admin and a password that is blank, and can be
configured without entering a password.
• Passwords are case sensitive.
• Disable all pop-ups with a popup blocker.
5. Click . The D-Link Embedded Web Interface Home Page opens:
Starting the D-Link Embedded Web Interface
Page 39
Getting Started