Modifying Qos Interface Settings - D-Link DES-3010FA Web User Manual
Layer 2 switch, managed 8 port 10/100base-tx with gigabit & fiber uplinks
Hide thumbs
Also See for DES-3010FA:
- Cli manual (361 pages) ,
- Cli manual (348 pages) ,
- Manual (348 pages)
Table of Contents
Advertisement
D-Link DES-3010FA/GA User Guide
Modifying QoS Interface Settings
The QoS Interface Page allows network managers to modify the QoS settings assigned to a specific interface. To
set the QoS interface settings:
1.
Click System > QoS > General Settings > Interface Settings. The QoS Interface Page opens.
Figure 120:QoS Interface Page
The QoS Interface Page contains the following fields:
•
Interface — The port or LAG for which the default CoS policy is defined.
•
Trust Mode — Indicates whether or not Trust Mode is enabled on the interface. The possible field values are:
–
Not enabled — Trust mode is not enabled on the interface.
–
Enabled — Trust mode is enabled on the interface.
•
Default CoS for Incoming Traffic — The default CoS value for incoming packets for which a VLAN tag is not
defined. The possible field values are 0-7. The default CoS is 0.
2.
Click
. The Edit Interface Settings Page opens:
Page 188
Advertisement
Table of Contents
Troubleshooting
