message received. Leave time must be greater than or equal to three times the join time. The default value is
60 centiseconds.
•
Leave All Timer — Indicates the amount of time lapse, in centiseconds, that all device waits before leaving
the GARP state. The leave all time must be greater than the leave time. The default value is 1000 centisec-
onds.
2.
Click
. The GARP Parameters Settings Page opens:
Figure 44: GARP Parameters Settings Page
3.
Modify the Interface, Join Timer (centiseconds), Leave Timer (centiseconds), and Leave All Timer (centisec-
onds) fields.
4.
Click
. The GARP parameters are defined, and the device is updated.
Page 84
Configuring VLANs
Configuring GARP