Configuring An Initial Https Password; Software Download And Reboot; Software Download Through Xmodem - D-Link Web Smart DES-3252P Install Manual

Configuring an Initial HTTPS Password

To configure an initial HTTPS password, enter the following commands:
Console(config)#
ip https authentication local
Console(config)#
username
Enter the following commands once when configuring to use a console, a Telnet, or an SSH session in order to
use an HTTPS session.
In the Web browser enable SSL 2.0 or greater for the content of the page to appear.
Console(config)# c
rypto certificate generate key_generate
Console(config)#
ip https server
When initially enabling an http or https session, enter admin for user name and user1 for password.
Note
HTTP and HTTPS services require level 15 access and connect directly to the configuration level access.

Software Download and Reboot

Software Download through XModem

This section contains instructions for downloading device software (system and boot images) using XModem,
which is a data transfer protocol for updating back-up configuration files.
To download a boot file using XModem:
1. Enter the command "xmodem:boot". The switch is ready to receive the file via the XModem protocol and dis-
plays text similar to the following:
Console# copy xmodem:boot
Please download program using XMODEM.
console#
2. Specify the path of the source file within 20 seconds. If the path is not specified within 20 seconds, the com-
mand times out.
To download a software image file using XModem:
1. Enter the command "xmodem:image". The switch is ready to receive the file via the XModem protocol.
2. Specify the path of the source file to begin the transfer process. The following is an example of the informa-
tion that appears:
Console# copy xmodem:image
Please download program using XMODEM
console#
admin user1
password level
Page 33
Initial Configuration
15