Viewing Optical Transceivers - D-Link Web Smart DES-3252P Install Manual

Viewing Optical Transceivers

The Optical Transceivers Page allows network managers to perform tests on Fiber Optic cables. Optical trans-
ceiver diagnostics can be performed only when the link is present. To test cables:
•
Click System > Diagnostics > Optical Transceivers tab. The Optical Transceivers Page opens:
Figure 168: Optical Transceivers Page
The Optical Transceivers Page contains the field:
•
Port — Displays the port on which the cable is tested.
•
Temperature — Displays the temperature (C) at which the cable is operating.
•
Voltage — Displays the voltage at which the cable is operating.
•
Current — Displays the current at which the cable is operating.
•
Output Power — Indicates the rate at which the output power is transmitted.
•
Input Power — Indicates the rate at which the input power is transmitted.
•
Transmitter Fault — Indicates if a fault occurred during transmission.
•
Loss of Signal — Indicates if a signal loss occurred in the cable.
•
Data Ready — Indicates the transceiver has achieved power up and data is ready.
Page 242
Managing Device Diagnostics
Viewing Optical Transceivers