Show Sdm Prefer - Cisco Catalyst 2960 Command Reference Manual

show sdm prefer

show sdm prefer
Use the show sdm prefer privileged EXEC command to display information about the Switch Database
Management (SDM) templates that can be used to maximize used for allocating system resources for a
particular feature.
Syntax Description default
qos
| begin
| exclude
| include
expression
Command Modes Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines When you change the SDM template by using the sdm prefer global configuration command, you must
reload the switch for the configuration to take effect. If you enter the show sdm prefer command before
you enter the reload privileged EXEC command, the show sdm prefer command shows the template
currently in use and the template that will become active after a reload.
The numbers displayed for each template represent an approximate maximum number for each feature
resource. The actual number might vary, depending on the actual number of other features configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show sdm prefer command:
Switch# show sdm prefer default
"default" template:
The selected template optimizes the resources in
the switch to support this level of features for
0 routed interfaces and 255 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
Catalyst 2960 Switch Command Reference
2-442
show sdm prefer [default | qos] [ | {begin | exclude | include} expression]
(Optional) Display the template that balances system resources among
features.
(Optional) Display the template that maximizes system resources for quality
of service (QoS) access control entries (ACEs).
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
8K
256
128
384
OL-8604-04