Removing The Device; Packaging The Device; Storing The Device - Kaco blueplanet gridsave 92.0 TL3-S Manual

12 | Decommissioning and dismantling
4. Insert the sealing plug in all open cable fittings.
ð The device is uninstalled. Proceed with disassembly.
12.4

Removing the device

↻ Unit has been switched off and uninstalled.
1. Remove the screw that prevents the device from being lifted off the mount.
2. Use the lateral openings and lift the device off the mount.
ð Device removed. Proceed with the packaging process.
12.5

Packaging the device

↻ Device has been uninstalled.
1. If possible, always pack the device in the original packaging. If this is no longer available, an alternative is to use equi-
valent packaging.
2. You must be able to close the box completely and it must be able to accommodate the weight and size of the device.
12.6

Storing the device

NOTE
Risk of damage to property as a result of condensation
Faulty storage can form condensate in the device and impair the functionality of the device (e.g. storage out-
side the ambient conditions or temporary relocation from a cold to a hot environment).
1. Prior to installation, check the inner area for condensation and if necessary, allow it to dry sufficiently be-
fore installation.
2. Store in accordance with the technical data > [See section 4.3} Page 13]
↻ Device packaged.
F Store the device at a dry location, in accordance with the ambient temperature range [See section 4.3} Page 13].
Page 90 blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
TL3-S