Configuration And Operation; Initial Start-Up - Kaco blueplanet gridsave 92.0 TL3-S Manual

9 | Configuration and operation

9 Configuration and operation
9.1

Initial start-up

When started for the first time, the device displays the configuration assistant. It takes you through the settings necessary
for the initial start-up.
NOTE
After configuration is completed, the configuration assistant does not appear again when the device is restar-
ted. You can then change the country setting only in the password-protected parameter menu. The other set-
tings can still be changed in the Settings menu.
NOTE
The DC power supply must be guaranteed during initial start-up.
The sequence of the settings required for initial start-up is pre-set in the configuration assistant.
Following successful authorisation and selection of the main menu option - Configuration , the installation wizard is
opened directly (if the device is still on the factory defaults and commissioning has not yet been carried out).
The installation wizard can still be relaunched at a later stage to make further changes to the original configuration.
The installation process currently consists of multiple steps which are outlined below.
Step: Language selection
↻ The installation wizard has been started or re-started.
1. Select Menu language via the dropdown menu.
2. Confirm the action field.
ð The Forward button jumps to the next installation step.
Step: Country configuration
↻ A language has been selected.
1. Select Country and Grid type from the dropdown menu.
2. Confirm the action field.
ð The Forward button jumps to the next installation step.
Step: Grid parameters
↻ The country and grid type have been selected.
. NOTE: By default, IP addresses are assigned via the plant DHCP server.
. NOTE: If static IP addresses are required, you will have to assign these.
. CAUTION! In this case, it is no longer possible to distribute the configuration
via the Segment Controller as this would then be part of the configuration and
ultimately all inverters in the same segment would be assigned the same IP
address.
1. Activate DHCP or enter the IP address at the deactivated DHCP.
2. Confirm the action field.
ð The Forward button jumps to the next installation step.
7
It is only possible to configure the grid parameters with DC voltage. The further parameters can also be con-
figured with a present AC voltage.
Page 34 blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
7
Fig. 35: Menu item: [See sec-
tion 9.4.2} Page 41]
Fig. 36: Menu item: [See sec-
tion 9.4.2} Page 41]
Fig. 37: Menu item: [See sec-
tion 9.4.2} Page 41]
TL3-S