Replacing The Fan - Kaco blueplanet gridsave 92.0 TL3-S Manual

11 | Maintenance and troubleshooting
↻ Cleaning the heat sink requires the fan to be removed.
↻ Switch off the device and secure it against restart.
↻ Keep a suitable brush ready for cleaning.
1. Remove the hood and fan [See section 11.3} Page 84].
2. Clean the free space between the cover and the heat sink using suitable
brushes.
3. Clean the heat sink with a suitable brush.
. NOTE: Do not use any aggressive cleaning agents and ensure that no other
components come into contact with fluids.
ð Cleaning completed - if necessary, remount the fans.
11.3

Replacing the fan

Removing the cover
↻ It has been ensured that there is no AC/DC voltage present.
1. Remove the fastening screws on the cover from both sides [ _T20]
2. Lift up the cover from both sides and press it out of the mounting clips.
3. Set the cover to one side.
ð Proceed with the cleaning or removal of the fans.
Page 84 blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
3x
2 mm
2
Fig. 73: Cleaning the cooling fins
from above
4x
2
Fig. 74: Cleaning the cooling fins
from below
1 Heat sink / space between
heat sink
2 Brush (max. wire diameter
2mm)
3
2
Fig. 75: Remove the cover
1 Cover
2 Screw for fixing
3 Mounting clips
4 Fan
1
1
1
TL3-S