Access Via Modbus - Kaco blueplanet gridsave 92.0 TL3-S Manual

Manual
↻ Pay attention to signal elements (LEDs) and statuses during the process.
↻ Note the description of the LED states during the process. [See section 9.2} Page 36]
1. Load the firmware from the KACO website onto a FAT32-formatted USB stick.
2. Insert the USB stick into the USB port of the device.
ð The update process starts once the firmware has been validated and the status LEDs flash to indicate this.
3. When the status LEDs "Operating" and "Feed-in" LED flash slowly at the same time, remove the USB stick.
4. Once the update has been successfully completed, all 3 LEDs light up briefly and the device restarts.
5. When an error occurs, the update process must be repeated.
ð Update process completed successfully.
Access to archive folders
↻ You have officially signed up via
catch up via our link mykacocom-kundenportal.
1. In the login screen, enter your full email address and password.
2. Now check if you have access to the archive folder shown in the graphic.
ð In the archive you will find all previous document versions as well as already ex-
pired certificates for your device.
You can check to see if the update was successful in the menu:
Displaying the firmware version
F Open the Information / SW version menu.
ð The device will display the versions and checksums of the software that is currently loaded.
9.7

Access via Modbus

NOTE
In order to make use of the Modbus functionality, we recommend using the "SunSpec-Modbus-Interface" spe-
cification we have made available for the firmware version installed on your device.
Follow the description in the document "Modbus-Protokol.pdf" in order to use the two Excel files with a high
level of process reliability.
↻ Firmware version of device is identical to the specifications of the Sunspec® Modbus®.
↻ NOTE: The device supports MODBUS/TCP and conventional SUNSPEC models. If there are concerns over security,
write access can be deactivated.
1. Enable the entry Network – Modbus TCP - Operation mode / Network services – Modbus TCP - Operation
mode in the menu on the device or on the web interface.
2. If necessary, allow write access.
3. Set up the Port for access. [Default: 502]
ð Access via Modbus enabled.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
Configuration and operation | 9
mykaco.com already registered. If not, please
Page 63