Monitoring The Device; Performing A Firmware Update - Kaco blueplanet gridsave 92.0 TL3-S Manual

9 | Configuration and operation
NOTE
With regard to the selection of country settings, KACO new energy attests:
1. that the relevant certificates are only valid if the corresponding country settings have been selected.
2. that all configured grid parameters must be configured in accordance with the requirements of the grid op-
erators.
3. that the configuration of parameters using IEEE 1547: 2003 table 1 is possible but is only permitted if it is
requested by the grid operators.
9.5

Monitoring the device

↻ You have connected the device to your network.
1. When using a DHCP server: Activate DHCP.
2. For manual configuration (DHCP off):
3. Open the Settings/Network menu.
4. Assign a unique IP address.
5. Assign a subnet mask.
6. Assign a gateway.
7. Assign DNS server.
8. Save your settings.
9.6

Performing a firmware update

NOTE
Ensure the active DC power supply of the device
It is only possible to update all of the device's components to the most current firmware version in this operat-
ing state.
NOTE
The DC power supply must be guaranteed during initial start-up.
The sequence of the settings required for initial start-up is pre-set in the configuration assistant.
CAUTION
Damage to the device from incorrect power supply
The update can fail if the power supply is interrupted during the update process. Parts of the software or of the device it-
self may be damaged.
1. Never disconnect the DC and AC power supply for or during a firmware update.
2. Do not remove the USB stick during a firmware update.
Performing a firmware update
You can upload the current firmware to the devices directly via the web interface. Refer to the menu items under "Firm-
ware Update" See table : Configuration via web user interface [} Page 60]
The firmware can be found on the website
There is the option of updating the firmware at the USB socket of the device. Observe the following procedure:
↻ Ensure that the power supply is connected.
9
It is only possible to configure the grid parameters with DC voltage. The further parameters can also be con-
figured with a present AC voltage.
Page 62
kaco-newenergy.com under Downloads / Software.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
9
TL3-S