Kaco blueplanet gridsave 92.0 TL3-S Manual page 27

Manual
1
Fig. 27: Communication circuit board (HMI board)
1 Communication circuit board
2 USB socket
3 SD- Slot
4 Ethernet for network connection DHCP
7.8.2 Inserting and laying the cables
DANGER
Risk of fatal injury due to electric shock!
Touching damaged insulation on the grid and battery connection leads results in severe injury or death.
1. Check the connection leads for damage.
2. All signal cables for interfaces must be correctly encased up to the connection using the insulation tube
provided before fitting the cable.
↻ Time required for connecting the interface cables: 10 min
1. Observe the instructions on the recommended cable for the interface used.
2. Unfasten the cover on the cable fitting [ W_20].
3. Feed the signal cable into the connection area.
ð Signal cable inserted.
Inserting the Ethernet cable
1. Unfasten and remove the cover on the cable fitting [ W_29].
2. Remove the sealing insert.
3. Pass the connection cable through the cover of the cable fitting and the sealing
insert.
4. Insert the sealing insert into the cable fitting.
5. Feed the connection cables into the connection area.
ð Ethernet cable inserted.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
1x RJ 45
7
USB
SD Card
-+ -+
3
2
5 INV OFF - connection for remote controls - 24V(+/-
20%) / 1A (at least 15mA)
6 ERR connection for external grid protection com-
ponent (fault signal relay)
7 Ethernet – only for starting up by means of static
IP ( [See section 8.2.2} Page 31])
Installation | 7
RS485
2x RJ 45
RS485
A
4
1
Fig. 28: Insert signal cables
1 Cable fitting for feeding in the
Ethernet cable
2 Cable fitting for feeding in the
signal cable
A B
GND
INV ERR
OFF
- +
B A B
GND GND
5 6
2
Page 27