User Interface - Kaco blueplanet gridsave 92.0 TL3-S Manual

Manual
Operating status LED status
The 3 LEDs also signal the firmware update process when a USB stick is inserted. The LEDs can assume other states for
this purpose:
LED flashes rapidly
Operating status LED status
Procedure in progress
Procedure has com-
menced (initialisa-
tion).
Process is initiated
(update)
Procedure completed
successfully.
Fault
No fault
9.3

User interface

NOTE
The values for the condition of the battery connected are transmitted from the EMS directly. We cannot
provide any guarantee that these values are correct.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
Configuration and operation | 9
Description
– There is no DC voltage present (e.g. DC isolator switch open)
– DC voltage too low (< starting voltage)
– DC voltage is present (> starting voltage), but communications con-
nection between the front end (operating unit) and back end (con-
trol unit) is faulty, or interrupted.
LED flashes slowly
Description
The green "Operating" LED is illuminated when the device is ready for
use.
Note: When updating via the web server and a USB stick is inserted in
parallel, the device remains inactive until the USB stick is removed or
then performs a reset and restarts.
The green "Operating" LED and the green "Feed-in" LED are flashing
quickly yet alternately.
Note: The procedure will last up to 5 min for firmware updates or up to
30 secs for parameter updates.
The green "Operating" LED and the green "Feed-in" LED are flashing
quickly.
The green "Operating" LED and the green "Feed-in" LED are flashing
slowly and in tandem.
Note: Check the new SW version via the web interface .
The red "Fault" LED is flashing slowly.
Note: The procedure has not been completed successfully or a time
limit has elapsed.
Important: If the USB stick is removed during the initialisation phase, a
device fault is triggered. Inserting the USB stick initiates a device re-
start.
No fault present.
LED flashes alternating
Page 37