Installing And Securing The Device - Kaco blueplanet gridsave 92.0 TL3-S Manual

Manual
ð Proceed with the installation of the device.
6.4

Installing and securing the device

CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
1. The device must be transported and installed by at least 3-4 persons.
2. Always lift the device vertically using the openings provided.
3. Use a climbing aid for the chosen installation height.
4. Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation mode
due to insufficient ventilation and the resulting heat build-up.
1. Observe minimum clearances and provide for sufficient heat dissipation.
2. All objects on the device housing must be removed during operation.
3. Ensure that no foreign bodies prevent heat dissipation following device installation.
2
Fig. 13: Lift the device using the opening
Key
1 Opening
2 Centre of gravity
Lifting and installing the device
↻ The mount has been installed.
1. Raise the device using the lower side recesses and support it on the head side. Observe the device's centre of gravity!
. NOTE: Do not lift the device by the lid or cover!
2. Fit the device onto the upper mount by means of the mounting bracket. Fit the device onto the lower mounting
bracket in full so that the device sits flush with its rear side on the mount ( [See figure 12 [} Page 18]).
3. Insert the screw provided into the lug of the mount and [ T30 /
ð Device is installed. Proceed with the electrical installation.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
Assembly and preparation | 6
3
1
Fig. 14: Fitting the device onto the mount
3 Mounting bracket
4 Mount
3
2 Nm ] ( [See figure 11 [} Page 18]).
4
Page 19