Fastening The Mount - Kaco blueplanet gridsave 92.0 TL3-S Manual

6 | Assembly and preparation
3. Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4. Set the unit with base and side sections upright.
5. Remove the top side section and base from the device.
ð If the unit is in the correct installation position: Proceed with the installation of the mount.
6.3

Fastening the mount

WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seriously
injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are only
to be used for masonry and concrete.
2. Only install the device in an upright hanging position.
153 mm
75 mm
B
A
D
C
Fig. 11: Minimum clearances for wall mounting
Legend
1 Mount
2 Fastening anchors [S12-Ø12 mm / 25 mm ]
3 Lock washer
A Minimum clearance: 120 mm
Recommended clearance: 400 mm
B Minimum clearance: 300 mm
C Minimum clearance: 500 mm
D Recommended clearance: 1000 mm
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1. Check condition and minimum room height according to specified dimensional data.
2. Mark the suspension position on the wall surface according to the bore holes in mounting plate.
. NOTE: The minimum clearances between two devices, or the device and the ceiling/floor have already been taken
into account in the diagram.
3. Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
. NOTE: Make sure that the mount is oriented correctly.
Page 18
2
1
A
6
3
4
A
Detail A
5
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
550 mm
453 mm
458 mm
1066 mm
2)
1543 mm
1)
475 mm
1)
270 mm
1)
475 mm
1)
270 mm
Fig. 12: Wall mounting
4 Screw for mounting (4x) [SW 13 / [See sec-
tion 6.3} Page 18]]
5 Screw for securing purposes (1x)
6 Bracket to store the device
1)
Minimum clearance excluding device:270 mm
1)
Recommended clearance excluding device:475 mm
- -
- -
²) Recommended clearance with DC breaker:1543 mm
1
5
6
TL3-S