Kaco blueplanet gridsave 92.0 TL3-S Manual page 33

Manual
– Ethernet cable (uncrossed patch cable)
Establishing a connection to the KACO device
1. The device must be opened in order to connect the Ethernet cable! The device has 3 Ethernet ports that can be used.
These are located on the printed-circuit board marked In this application only one of the 2 neighbouring shielded Eth-
ernet ports (marked LAN1 and LAN2) should be used. These ports have an internal switch and, in their factory default
state, they expect to receive an IP address from a DHCP server.
. NOTE: Please do not under any circumstances connect the Ethernet cable to the unshielded RJ45 slot marked J200
as this typically causes damage to the printed circuit board!
2. Use a functioning Ethernet slot on the external network end.
3. It may be necessary to take additional IT configuration measures in the external network so that the device is as-
signed an IP address.
4. Next, launch the browser on the terminal device and enter the IP address of the device:
ð http://<Device-IP-Adress>
ð The IP address can either be requested from the network administrator or determined using an IP scanner tool.
http://bg137-137TL01234567
↻
F If this is unsuccessful, please use the full domain name:
http://bp137-137TL01234567<ExternalNetworkDomainName> or http://bg92-92-0TL01234567<ExternalNetwork-
DomainName>
6
If the device serial number features a "." dot, then this "." dot is replaced with a "-" dash in the host name as,
according to RFC229, host names must not contain any "." dots.
For local host names, only characters in the range [a-z], [A-Z] and the minus character are permitted.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
or http://bg92-92-0TL01234567
Commissioning | 8
6
Page 33