Kaco blueplanet gridsave 92.0 TL3-S Manual page 58

9 | Configuration and operation
Country- Level Display/
spec. Set- Setting
tings
Modbus
3
1 2 4 4
Activation
1 2 3 4 4
Status
Write access
1 2 3 4 4
Status
Port
1 2 3 4 4
MQTT
3
1 2 4 4
Broker IP
1 2 3 4 4
Broker port
1 2 3 4 4
Features / Functions
1
2 3 4 4
Digital Inputs / Outputs
2
1 3 4 4
Relay
1 2 3 4 4
Positive logic | Neg-
ative logic
inactive | active
System Control
2
4 4
1 3
Control mode
1 2 3 4 4
EMS / Local
Active
Button: Update
1 – 10 [sec]
Repeat: Active
Power Unit state
1 2 3 4 4
Requested state
4 4
1 2 3
Mode: Off, Standby,
Connected
Column: Local
1 2 3 4 4
Column: EMS
Column: Active
Current status
1 2 4 4
3
Buttons in the menu:
1 2 3 4 4
Device control
Page 58
Action in this menu/meaning
NOTE: Opportunity to set the Modbus port.
F Allow Modbus TCP reading access.
F Allow Modbus TCP write access..
Enabling the write access allows system critical settings to be changed
over Modbus TCP. Really enable write access?
F Confirm the action field.
F Set network port.
NOTE: The MQTT protocol is used to implement the advanced func-
tions between the Segment Controller and the inverter (in particular,
firmware updates, distribution of device configurations etc.).
1. Displays the IP address transmitted by the Segment Controller.
. NOTE: The standard settings allow for successful communication
with the Segment Controller.
2. Confirm the action field.
NOTE: Input screens for advanced device functions
NOTE: Opportunity to configure the fault signal relay [ERR].
1. Select the type of logic.
2. Select the form of activity.
3. Confirm the action field.
NOTE: Displays the values transmitted by a connected EMS. However,
controls the unit even without an EMS.
NOTE: Default values are active after every device restart.
NOTE: Changes only affect the selected mode.
EMS / F Select EMS or local mode.
Note: In EMS mode, the values for local mode are read-only. In mode
local the values for the local mode to be changed by service and in-
staller.
F Displayed values:
-cyclical: every second (default setting) or
1 [sec]
- manuel via the update button.
NOTE: View the status of the power unit
Connection status: see in the "SunSpec Information Model Reference
KACO" document under Model- 64201 "enum16" as well as in the Integ-
ration Manual.
The unit reacts to the local values specified via the web interface.
Unit reacts to the values sent by the EMS.
Unit reacts to the status of the power unit.
Displays system status.
NOTE: Save settings for watchdog, battery limits, P and Q setting.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
Manual
TL3-S