Kaco blueplanet gridsave 92.0 TL3-S Manual page 35

Manual
Step: Localisation
↻ Grid parameters have been set.
1. Set Date, time and time zone or initiate synchronisation with the client.
2. NOTE: An NTP server needs to be activated for synchronization purposes
3. Select temperature unit from the dropdown menu.
4. Confirm the action field.
ð The Forward button jumps to the next installation step.
Step: Cloud & portal configuration
↻ Localisation has been carried out.
1. If available, activate Web portal and select Portal from the dropdown menu.
2. Configure the portal.
3. Confirm the action field.
ð The Forward button jumps to the next installation step.
Step: ModBus
↻ Portal configuration completed.
. NOTE: The device supports MODBUS/TCP and conventional SUNSPEC models.
If there are concerns over security, write access can be deactivated.
1. Specify the Modbus port and determine Read/write access.
2. Confirm the action field.
ð The Forward button jumps to the next installation step.
Step: Optional parameters
↻ Modbus has been specified.
. NOTE: Using the plant ID, the device followed by its firmware version can be
detected automatically in the Cloud/portal and assigned to the relevant plant.
1. Enter the device name used to reach the device in the network.
. NOTE: The coordinates identify the device installation location.
2. Confirm the action field.
ð The Forward button jumps to the next installation step.
8
It is preferable to install this on a plant component. It is also possible to select an NTP server localized on the
internet provided the device has direct access to the internet.
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
Configuration and operation | 9
8
Fig. 38: Menu item: [See sec-
tion 9.4.2} Page 41]
Fig. 39: Menu item: [See sec-
tion 9.4.2} Page 41]
Fig. 40: Menu item: [See sec-
tion 9.4.2} Page 41]
Fig. 41: Menu item: Only on the in-
stallation wizard!
Page 35