Description Of The Device; Mode Of Operation; Device Diagram - Kaco blueplanet gridsave 92.0 TL3-S Manual

Manual
3

Description of the device

3.1

Mode of operation

2
An external EMS/PMS is required to operate the device. The EMS/PMS must be provided by the customer/system integ-
rator. Modbus TCP is the sole means of communication with the device.
The necessary commands and data points are described in the SunSpec Protocol description [See section 1.1} Page 4].
The shutdown threshold (DC-Min.) is dynamically determined by the device on the basis of the current grid voltage. After
shutting down the device, it is therefore not possible to guarantee reconnection as there may be a change in the grid
voltage.
3.2

Device diagram

4
3
2
1
Fig. 3: Device diagram
Key
1 Housing
2 Cover
3 Upper cover
4 Status indicator
3.2.1 Electrical functions
A potential-free relay contact is integrated into the device. Use this contact for one of the following functions:
Potential-free relay
The potential-free relay contact closes as soon as there is a fault during operation. You use this function, for example, to
signal a fault visually or acoustically.
2
Energy management system/power management system
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137
TL3-S
Description of the device | 3
5
6
7
8
5 AC connection / cable feed-through
6 Interface / cable feed-through
7 Communication - button / USB port
8 DC connection / cable feed-through
Page 9