Table of Contents
Advertisement
UTG9000T Series Function Abitrary Waveform Generator
Figure 2-1 Front Panel Structure
①. ON/OFF
Supply voltage of power source is AC 100V~240V. Frequency is 45Hz~440Hz.Connect the instrument to the power
source with power line in accessories or other lines up to standard. Toggle on the power switch on the back panel to
operate the instrument. Turn ON/OFF:
backlight is on (red) when power supply in normal.Press the key, the
backlight is on (green).Aferwards, the screen enters function interdace after displaying start-up interface. In order to
prevent accidentally touching ON/OFF to turn off the instrument, this switch key needs to press about 1s to turn off
the instrument. The backlight of the key and screen are simultaneously off after turning off the instrument.
②．USB Interface
The instrument supports U disks of FAT32 with maximum capacity of 32G. USB interface can be used to save and
read the current stauts file. USB interface can also used to upgraded the system program, to ensure that the current
program of function/abitraty generator is the latest version released by the company.
③．Channel Output Terminal
Output the signal of the wave.
④．Channel Control Terminal
Channel control terminal, which is channel output switch. There are three ways to operating:
1) Quick switch the current channel (CH bar is highlight, which measns it is the current channel, parameter tab shows CH1
information for the wave parameter settings.) The CH1 can turn on/off the output function of the current channel quickly.
2) Tap UTILITY → Channel, turn on the output function.
3) Touch the channel setting on the left side of the screen.
Starting output function, the backlight of the CH1 will be light on, the channel tab displays output mode of the current
channel (shows"continue", "modulate"words, etc.), and the channel output terminal export the signal at the same time. Turn
off the output function, the backlight of the CH1 will be also light off, the channel tab becomes grey and the channel output
terminal closed.
⑤．Numeric Key and Utility
The numeric key is used to enter numbers 0~9, decimal point ".", symbol key "+/-" and delete key. Utility key is used to set
13
Advertisement
Table of Contents
