UNI-T UTG9504T User Manual page 31

UTG9000T Series Function Abitrary Waveform Generator
external clock is effect, it displays the symbol
6. Clock Output
Tap Clock Output to step through OFF/ON. Turn on the clock output, the terminal of 10MHz Out for other
instrument.
The synchronization approach between the instruments:
Connect the terminal of 10MHz Out of the first instrument (Clock Output ON) with the the terminal of 10MHz In of the
other instrument (Clock source External), and set both of them at the same output frequency to implement the sync.
Multi-instrument can sync with others as the same steps.
7. Phase
Tap Phase step through Sync/Independent.
Sync: The start phase of four channels are associated.
Independent: The start phase of channel is independent.
8. Power On
Tap Powe On to step through Default, Last, Set1, Se2, Set3, Set4, and Set5.
Set the start stauts of the instrument, select the preview settings of save function.
9. Manual
Tap Manual to step through SingleChannel/AllChannel.
When trigger source is enabled in Sweep or Burst mode, the SingleChannel function can only work on the
current channel. The AllChannel function can work on all the channel at the same time which the channel trigger
source is turned on.
10. Save
Tap Save to keep the current settings as the preview settings, it can select to keep into Set1, Set2, Set3, Set4
and Set5.
Default
Tap Default to restore the instrument to "Factory settings", pop-out dialog box, and tap it to Cancel/Ok.
11. About
Display model name, version information and company address, etc.
LAN
Menu
.
Table 2-8 LAN Settings
Sub-menu Setting
DHCP OFF/ON
IP address
Mask
Gateway
MAC
Description
Turn off to set the following option
31