Table of Contents
Advertisement
UTG9000T Series Function Abitrary Waveform Generator
4）Turn on the output channel
Tap channel Out botton to ON or push CH1 key on the front panel to quick set the output channel,and it can
aslo turn on at the Utility interface,tap Utility→Channel→Output or double-click the channel tab bar at the
bottom of the screen to step through ON/OFF. CH1 key and CH1 tab bar backlight light on indicating that the
channel 1 output is turned on.
The shape of the FM modulation waveform viewed through an oscilloscope is shown in the figure below,
3.2 Output Frequency Sweep Waveform
In frequency sweep mode, the funcyion/arbitrary waveform generator can output the frequency from starting to stop
103
Advertisement
Table of Contents
