by the mode of linear, logarithm, stepping and list sweep in designated sweep time. Trigger source can be internal,
external or manual it can generate frequency sweep output for sine, square, sawtooth ramp and arbitrary wave
(except DC). The modulation modes for each channel are independent, it can set the same or different modulation
modes to each channel.
3.2.1 Select Frequency Sweep
1)
Turn on frequency sweep mode: tap CH1→Sweep accordingly, the instrument output the current frequency
sweep waveform.
2)
Select the frequency sweep waveform
Tape Base tap Base to present the carrier waveform on the right side. See the interface figure as below,
3.2.2 Starting and stop frequency settings
Starting and stop frequency are the upper limit and lower limit of frequency sweep.The function/arbitrary waveform
generator is always sweeps from starting frequency to stop frequency. Rotate multifunction knob, push direction key or tap
Start, Stop tab to pop-out visual numeric keyboard to enter values and select unit in sweep modulation setting interface.
UTG9000T Series Function Abitrary Waveform Generator
104