Comperhensive Example - UNI-T UTG9504T User Manual

terminal used as input (external trigger source), rising edge means that rising edge of external signal triggers output
a frequency sweep; falling edge means that falling edge of external signal triggers output a frequency sweep. When
the terminal used as output (internal trigger or manual trigger source), rising edge represents the rising edge output
trigger signal; falling edge represents the falling edge output trigger singal, and the default is rising edge.

3.2.8 Comperhensive example

In frequency sweep mode, set a square wave with amplitude 1Vpp, duty ratio 50% as frequency sweep, the
frequency sweep type is linear, set the starting frequency to 1kHz, stop frequency 50kHz and frequency sweep
time to 2ms, use the internal rising edge trigger source to output frequency sweep. The settings steps as following,
Turn on FM modulation mode: tap CH1→Sweep→Linear accordingly
1) Set the parameter of the carrier wave signal
Tap Base to select square wave (the default option is sine wave.) See the interface figure as below,
Tap Ampl tab to pop-out visual numeric keyboard to enter 1Vpp.
UTG9000T Series Function Abitrary Waveform Generator
108