UNI-T UTG9504T User Manual page 111

UTG9000T Series Function Abitrary Waveform Generator
Select waveform
1)
N cycle mode supports sine, square, ramp, pulse and arbitrary wave (expect DC).

Gating mode supports sine, square, ramp, pulse, arbitrary (expect DC) and noise wave.

Infinite mode supports sine, square, ramp, pulse and arbitrary wave (expect DC).

After select waveform, tap Base to present the carrier waveform on the right side (sine wave as default.)
2) Set waveform frequency
In N cycle and gating modes, waveform frequency defines the signal frequency during period of pulse train,
In N cycle mode, output the pulse train at a specified cycle times and waveform frequency. In gating mode,
use waveform frequency to output the pulse string when the trigger source is high level.
Note: Waveform frequency is different from pulse string period. Pulse string is used to specify the interval
between pulse strings (only in N cycle mode). The default frequency is 1kHz, refer to
frequency settings
Rotate multifunction knob, push direction key or tap Freq tab to pop-out visual numeric keyboard to enter
values and select unit.
of AM modulation.
111
The carrier wave