Amplitude output settings
DC offset voltage settings
Square wave settings
Pulse wave settings
DC voltage settings
Ramp wave settings
Noise wave settings
Harmonic wave settings
PRBS settings
Noise superposition settings
2.3.1 Frequency Output Settings
The instrument output of a sine wave is frequency 1kHz, amplitude 100mVpp (default setting) when activating the
instrument.
The step to set the frequency to 2.5MHz:
1) Tap the parameter lisrt area of Frequency tab, pop-out the virtual numeric keyboard to enter 2.5MHz (or rotate
the knob and direction key to make the settings.)
2) Tap word Frequency to step through Frequency/Period
Note: multifunction knob/direction key is also can used to make parameter settings.
2.3.2 Output Amplitude Settings
The instrument output of a sine wave amplitude is 100mV peak value (default setting) when activating the instrument.
The step to set the amplitude to 300mVpp:
1)Tap Amplitude tab,pop-out the virtual numeric keyboard to enter 300mVpp
2)Tap word Amplitude to step through unit of Vpp、Vrms、dBm
Note: dBm setting only enable when Load is no HighZ mode
Figure 2-4 Frequency Settings
18
UTG9000T Series Function Abitrary Waveform Generator