Frequency Sweep Mode - UNI-T UTG9504T User Manual

UTG9000T Series Function Abitrary Waveform Generator
When starting frequency < stop frequency, the function/arbitrary waveform generator sweeps from low to

high frequency.
When starting frequency > stop frequency, the function/arbitrary waveform generator sweeps from high to

low frequency.
When starting frequency = stop frequency，the function/arbitrary waveform generator outputs a constant

frequency.
The synchronous signal of frequency sweep mode is low from starting point to midpoint of frequency

sweep time, and high from midpoint to end of frequency sweep time.
By default, starting frequency is 1kHz and stop frequency is 1Mz, but the range of starting and stop frequency
can vary with frequency sweep waveform. See the Table 4-1/4-2 Carrier frequency settings of AM.

3.2.3 Frequency Sweep Mode

UTG9000T has four frequency sweep mode: linear, logarithm, stepping and list sweep
Linear frequency sweep: output frequency in a linear way
Logarithm frequency sweep: output frequency in a logarithm way
Stepping frequency sweep: output frequency in a stepping way
List frequency sweep: output frequency in a list way
Linear frequency sweep mode is default. Tap Sweep→Type to select Line, Log, Step, and List mode.
105