Prbs Wave Settings; Noise Superposition Settings - UNI-T UTG9504T User Manual

UTG9000T Series Function Abitrary Waveform Generator
Figure 2-12 Ramp Wave Settings

2.3.10 PRBS Wave Settings

The step to set the PRBS wave to bit rate 50kbps, amplitude 4Vpp, code element PN7, and edge time 20ns:
1）Tap Continue tab to select PRBS.
2）Tap Bitrate tab, pop-out the virtual numeric keyboard to enter 50kbps.
3）Tap Amplitude tab, pop-out the virtual numeric keyboard to enter 4Vpp.
4）Tap PN code tab, pop-out the virtual numeric keyboard to enter PN7.
The default edge time is 20ns.
Figure 2-13 PRBS Wave Settings

2.3.11 Noise Superposition Settings

UTG9000T function/arbitrary waveform generator can add noise. The SNR is adjustable. The step to set the sine
wave of frequency 10kHz, amplitude 2Vpp, DC offset 0V, signal noise ratio 0dB:
1) Tap Continue tab to select Sine.
2) Tap Frequency tab, pop-out the virtual numeric keyboard to enter 10kHz.
3) Tap Amplitude tab, pop-out the virtual numeric keyboard to enter 2Vpp.
4) Tap Noise to turn on.
23