Table of Contents
Advertisement
1) Turn on QPSK modulation mode: tap CH1→Modulate→QPSK accordingly.
2)
Set the parameter of the carrier wave signal
Tap Base to select sine as the carrier wave (the default option is sine), so this step has no change.
Tap Freq to pop-out visual keyboard to enter 2kHz.
Tap Ampl to pop-out visual keyboard to enter 2Vpp.
3）Set QPSK bitrate and the modulating phase
After the parameter setting of the carrier wave, tap Type to return to modulation interface to set the QPSK bitrate
and phase.
UTG9000T Series Function Abitrary Waveform Generator
78
Advertisement
Table of Contents
