UTG9000T Series Function Abitrary Waveform Generator
2)
Set data parameter
Tap Clock to pop-out visual numeric keyboard to enter 15kHz.
Tap Interval to pop-out visual numeric keyboard to enter 5ms.
Tap blank input box to enter 17, 19, 29, 29, 31.
3)
Turn on output function
Tap OFF to turn on the output function, CH3 is IIC-SCL,CH4 is IIC-SDA. See the figure as below.
3.5.3 UART Protocol
The waveform generator can create configurable serial protocol signal parameters in UART protocol mode.
Select UART mode
Tap Utility → Digital → UART accordingly, turn on UART mode to output the current UART protocol signal.
Set baud rate
Baud rate can set by user's need. In UART mode, tap Baudrate to pop-out visual numeric keyboard to enter values
and select unit. The baud rate range can set to 1-1000000.
Data format setting
The data format of UART can set by user's need. It have two format types: hexadecimal and character.In UART mode, tap
133