Table of Contents
Advertisement
UTG9000T Series Function Abitrary Waveform Generator
3）Set the parameter of the modulating signal
After the parameter setting of the carrier wave, tap Type to return to modulation interface to set the frequency.
Tap ModSrc tab to pop-out visual numeric keyboard to enter 300Hz.
4）Turn on the output channel
Tap channel Out botton to ON or push CH1 key on the front panel to quick set the output channel,and it can aslo
turn on at the Utility interface,tap Utility→Channel→Output or double-click the channel tab at the bottom of the
screen to step through ON/OFF. CH1 key and CH1 tab backlight light on indicating that the channel 1 output is
turned on.
53
Advertisement
Table of Contents
