Output The Carrier Wave - UNI-T UTG9504T User Manual

UTG9000T Series Function Abitrary Waveform Generator
virtual numeric keyboard pop-out ,see Figure 2-4
⑥.CH tab: the current channel which choosed will be highlight.
1) "HighZ"presents load with high resistance,it can set to be 50Ω.
2) pesents the output wave is sine wave.
3)"Continue"presents the output wave is continue wave, which is output carrier wave only.( Other different mode
may presents "carrier wave","AM","linear"or "N period")
⑦.Wave Display Area: display the current waveform (it can distinguish by color or highlight of the CH tab, parameter
list display the current waveform parameters on the left side.)
Note: There is no waveform display area in Utility page.
⑧.CH Status Settings: quick switch the general settings of the current channel. Tap channel tab to switch output
on/off to enable the channel output;inverse on/off to enable output the inverse waveform;load on/off to enable
HighZ or 50Ω to match the resistance of the output terminal;
⑨.System Settings: display USB connecting status, LAN symbol, external clock, etc.

2.3 Output the Carrier wave

UTG9000T series function/arbitrary waveform generator can output the carrier wave by single channel or four
channel, including sine wave, square wave, ramp wave, pulse wave, harmonic wave, noise, PRBS (pseudo random
binary sequence), DC, arbitrary wave. The instrument output a sine wave frequency 1 kHz, amplitude 100mVpp
(default setting) when activating.
This section is to introduce how to set the output of the carrier wave, the contents as following:
Frequency output settings

Figure 2-4 Parameter Editing
can copy the CH2 settings to CH1
17