Ramp Wave Settings; Noise Wave Settings - UNI-T UTG9504T User Manual

UTG9000T Series Function Abitrary Waveform Generator
1) Tap Continue tab to select DC wave mode.
2) Tap Offset tab,pop-out the virtual numeric keyboard to enter 3V.
Figure 2-9 DC Settings

2.3.7 Ramp Wave Settings

The symmetry presents the ramp slope is the positive of time quatunm in each cycling (assuming that the waveform is not
inverse.) The default value of the symmetry of ramp wave is 50%.
The step to set frequency 10 kHz, amplitude 2Vpp, DC offset 0V, symmetry 60%:
1）Tap Continue tab to select Ramp, pop-out the virtual numeric keyboard to enter 10kHz.
2）Tap Ampiltude tab, pop-out the virtual numeric keyboard to enter 2Vpp.
3）Tap Symmetry tab, pop-ou numeic keyboard to enter 60%.
Figure 2-10 Ramp Wave Settings

2.3.8 Noise Wave Settings

The default value of amplitude is 100mVpp, DC offset is 0mV (standard gaussian noise). If other wave's amplitude and DC
offset function has changed, the default value of noise wave will also be change. So it can only set the amplitude and DC
offset in noise wave mode.
The step to set frequency 100MHz, amplitude 300mVpp:
1）Tap Continue tab to select Noise wave mode.
2）Tap Frequency tab, pop-out the virtual numeric keyboard to enter 100MHz.
3）Tap Amplitude tab, pop-out the virtual numeric keyboard to enter 300mVpp.
21