Jumper Settings; At/Atx Power Select Jumper Settings; Table 4-1: Jumpers - IEI Technology KINO-PVN-D5251 User Manual

KINO-PVN-D5251/D4251/ Mini ITX SBC

4.6 Jumper Settings

NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Before the KINO-PVN-D5251/D4251 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-PVN-D5251/D4251
are listed in T able 4-1.
6
Description
AT/ATX Power setting
Clear CMOS
CompactFlash® setting
Serial port setting

Table 4-1: Jumpers

4.6.1 AT/ATX Power Select Jumper Settings

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Type
3-pin wafer
3-pin header
2-pin header
8-pin header
ATXCTL1
3-pin header (1x3)
See Table 4-2
See Figure 4-4
Label
ATXCTL1
J_CMOS1
JCF1
JP3
Page 43