Jumper Settings; At/Atx Power Selection Jumper; Table 4-1: Jumpers - IEI Technology WAFER-CV-D25501 Series User Manual

Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the

4.4 Jumper Settings

NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.
Description
AT/ATX power selection
Clear CMOS
LVDS1 voltage selection
LVDS2 voltage selection
LVDS2 panel type selection

Table 4-1: Jumpers

4.4.1 AT/ATX Power Selection Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Page 42
WAFER-CV-D25501/N26001 3.5" SBC
socket.Step 0:
a jumper means
Label
JP2
JP3
JP4
JP1
SW1
JP2
2-pin header
See Table 4-2
See Figure 4-2
Type
2-pin header
3-pin header
3-pin header
3-pin header
4-pin switch