Table of Contents
Advertisement
Figure 4-2: PCIe Mini Card Installation
Step 1:
Insert into the socket at an angle. Line up the notch on the card with the notch
on the connector. Slide the PCIe Mini card into the socket at an angle of about
20º.
Step 2:
Push down until the card clips into place. Push the other end of the card
down until it clips into place on the plastic
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Page 44
NANO-QM770 EPIC SBC
connector.Step 0:
Advertisement
Table of Contents
