Mr-Results Card For Advanced Mr Test Mode; Available Soft Keys - Omicron CT SB2 User Manual

CT SB2 User Manual
9.3

MR-Results card for Advanced MR Test mode

After the test is finished, the MR-Results card shows the measurement results for each tap combination
and/or intertap combination enabled for testing in the MR-Config. card.
If necessary, use the
Figure 9-3: MR-Results card with measurement results: Page for ratio results (left) and page for
excitation results (right)
The MR-Results card can be switched to display
• the ratio results or the excitation results (see "Ratio results and excitation results" on page 55),
• the results for the tap combinations or the intertap combinations of the CT (see Show Inter Taps and
Show Taps on page 55), and
• the results with the nominal burdens or the operating burden (see section 9.3.2 on page 55).
9.3.1

Available soft keys

The following soft keys are available in the MR-Results card.
Table 9-4: Soft keys available in the MR-Results card
Soft key Description
Use this soft key to switch between the ratio results and the excitation results.
If the ratio results are displayed, the soft key is labeled Show Excit. to display the
excitation results.
If the excitation results are displayed, the soft key is labeled Show Ratio to display the
ratio results.
By default, the results are displayed for the nominal burden values.
Use the Results with Op. Burden soft key to display the results for the operating
burden instead. The operating burden is the same for all tap combinations.
If the results are displayed for the operating burden, the soft key changes to
Results with Nom. Burden to toggle back to the results with nominal burden.
See section 9.3.2 below.
Using this soft key you can switch the unit for the phase error ("Pol. (')" column)
between minutes and degrees.
If the phase error is displayed in minutes, the soft key is labeled Pol. in Degrees. If the
phase error is displayed in degrees, the soft key is labeled Pol. in Min..
54
cursor keys to scroll the display.
OMICRON