Performing Measurements With Quick Test - Omicron CT SB2 User Manual

Table 10-1: Measurements available in Quick Test (continued)
Meas. type Usage
CT Ratio Predefined type, especially intended for quick measurement of CT ratios. Adjustable
measurement quantities are the voltage and the frequency of the output signal and
the resistance and inductance of the CT to be measured.
For details, please refer to section 10.6 on page 155.
VT Ratio Predefined type, especially intended for quick measurement of VT ratios. Adjustable
measurement quantities are the voltage and the frequency of the output signal.
For details, please refer to section 10.7 on page 157.
Resistance Predefined type, especially intended for quick measurement of resistances. The only
adjustable measurement quantity is the value of the output current.
For details, please refer to section 10.8 on page 160.
Impedance Predefined type, especially intended for quick measurement of impedances.
Adjustable measurement quantities are the amplitude and the frequency of the
current output signal.
For details, please refer to section 10.9 on page 163.
Reactance Predefined type, especially intended for quick measurement of reactances.
Adjustable measurement quantities are the voltage and the frequency of the output
signal.
For details, please refer to section 10.10 on page 165.
10.3

Performing measurements with Quick Test

Measurements using Quick Test are not automatically stopped by
CT Analyzer. Such measurements have to be stopped manually by the user.
Proceed as follows to perform measurements using the Quick Test feature:
1. Select New Quick-Test from the main menu and press the OK soft key to
open Quick Test. The display then shows the CT-Quick card.
Figure 10-2: CT-Quick card
2. Select the measurement type and connect your test object to CT Analyzer correspondingly (see
sections 10.4 to 10.10 below).
3. Define your measurement quantities.
4. Start and stop your measurement by pressing the
5. After starting a measurement, the Results card is displayed automatically, showing the
measurement results.
OMICRON
Using the Quick Test feature
key.
How to get there:
Press the Main soft key in
any test card
Main Menu:
- New Quick-Test
OK soft key
-> CT-Quick card
145