Power On And Start Operation - Danfoss ICM User Manual

ICM and ICMTS Motorized Valves with ICAD Actuators
Figure 15: STATUS BAR
Alarm | Warning | Service overdue | Modbus address | Bluetooth ON | UPS enabled
ICAD name
EXIT
Back one level
On main screen show alarms
Show I/O status
2. Once you are in the menu, use the UP (3) and DOWN (1) arrows to move through the list of parameters
3. To display and/or change the value of the parameter, press ENTER button to view the current settings
3.1. To change the value of a parameter, use the up or down arrow to establish the new value for that
parameter
3.2. Once the new value for the parameter has been selected, press ENTER button to save the change and
return to the menu
3.3. Repeat this procedure for all parameters
3.4. Exit from the parameter list by pressing EXIT button or simply wait for the ICAD to return to the main
display

Power on and start operation

ICAD has a light guide viewable from three sides, which indicates the status. Immediately after power on the light
guide and display lights up.
© Danfoss | Climate Solutions | 2024.01
ARROW UP
Navigate up
Actual opening degree
Status
ENTER
Open menu / Down one level
Set parameter on lowest level
ARROW DOWN
Navigate down
Show I/O status
BC465027827472en-000102 | 16