HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 97

3. Install the access panel.
4. Slide the server into the rack.
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server.
8. Admit the new card to the Pensando Policy and Services Manager (PSM).
For more information, see the replacement instructions for the card on the Hewlett Packard Enterprise website
https://www.hpe.com/support/hpesc https://www.hpe.com/support/hpesc
Removing and replacing the front I/O board in the LFF right chassis ear Removing and replacing the front I/O board in the LFF right chassis ear
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
T-10 Torx screwdriver
Small flat head screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack .
4. Remove the access panel .
5. Remove the cable protection panel.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 97