HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 71

8. Feeding the cables through the front of the server, remove the power switch module.
To replace the component, reverse the removal procedure.
Removing and replacing the SFF optical drive Removing and replacing the SFF optical drive
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the fan cage.
6. Disconnect all cables from the SFF universal media bay.
7. Remove the SFF universal media bay .
8. Remove the optical drive.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 71