HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 125

Item Item Description Description
1 Power On/Standby button
and system power LED
2 Health LED
1
3 NIC status LED
1
4 UID button/LED
1
1
If all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has occurred, or
the power button cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
LFF power switch module LEDs and buttons LFF power switch module LEDs and buttons
Status Status
Solid green = System on
1
Flashing green (1 Hz/cycle per sec) =
Performing power on sequence
Solid amber = System in standby
Off = No power present
Solid green = Normal
Flashing green (1 Hz/cycle per sec) = iLO is
rebooting
Flashing amber = System degraded
Flashing red (1 Hz/cycle per sec) = System
3
critical
Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network
active
Off = No network activity
Solid blue = Activated
Flashing blue:
1 Hz/cycle per sec = Remote management
or firmware upgrade in progress
4 Hz/cycle per sec = iLO manual reboot
sequence initiated
8 Hz/cycle per sec = iLO manual reboot
sequence in progress
Off = Deactivated
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide
2
125