HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 106

6. Disconnect and remove the serial cable.
To replace the component, reverse the removal procedure.
Removing a rear serial port interface (secondary and tertiary) Removing a rear serial port interface (secondary and tertiary)
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Disconnect the cable.
6. Remove the riser cage.
7. Using a T-10 Torx screwdriver, remove the serial port interface.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 106