HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 4

Drive backplane board spare parts
Chassis Intrusion Detection Switch spare part
Rear serial port interface spare part
Accelerator spare parts
HPE DL38x Gen10 12Gb SAS Expander Card spare part
Energy pack spare parts
Power switch module spare parts
Pensando Distributed Services Platform card spare part
Flex bay spare parts
Midtray drive cage spare part
Cable spare parts
SAS/SATA cable spare parts
NVMe cable spare parts
Power cable spare parts
Miscellaneous cable spare parts
Thermal grease spare part
Customer self repair
Removal and replacement procedures
Safety considerations
Electrostatic discharge
Symbols on equipment
Server warnings and cautions
Preparation procedures
Access the Systems Insight Display
Power down the server
Power up the server
Extend the server from the rack
Remove the server from the rack
Remove the access panel
Removing the air baffle
Release the full-length expansion board retainer
Releasing the cable management arm
Removing and replacing the front bezel
Removing and replacing a hot-plug SAS, SATA or NVMe drive
Removing and replacing a drive blank
Removing and replacing the cable management arm
Removing and replacing a power supply
Power supply warnings and cautions
Removing and replacing a hot-plug AC power supply
Removing and replacing the HPE 800 W Flex Slot -48 VDC hot-plug power supply
Removing and replacing an HPE 1600 W Flex Slot -48 VDC hot-plug power supply
Removing and replacing a power supply blank
Removing and replacing the rack rails
Removing and replacing the hot-plug fan