HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 63

3. Disconnect any external cables that are connected to the expansion board.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
5. Remove the access panel .
6. Disconnect any internal cables that are connected to the expansion board.
7. Removing and replacing an expansion board .
8. Remove the PCIe riser cage.
To replace the component, reverse the removal procedure.
Removing and replacing the PCIe riser blank Removing and replacing the PCIe riser blank
CAUTION: To prevent improper cooling or thermal damage, the server PCI slots must have an expansion slot blank or CAUTION:
an expansion board installed.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 63