Table of Contents
Advertisement
a. Use a T-20 Torx screwdriver to loosen the captive screws in the sequence specified on the heatsink label.
b. Lift the heatsink away from the system board.
c. Place the heatsink on a flat work surface with its contact side facing upward.
9. Use an alcohol wipe to remove the existing thermal grease from the heatsink.
Allow the alcohol to evaporate before continuing.
10. Use a T-20 Torx screwdriver to loosen the three captive screws in the sequence shown in the following image, and then pivot the
force frame upward.
11. Remove the processor:
a. Hold the lift tabs near the front end of the rail frame, and then pivot the rail frame to the vertical position.
b. Slide the processor out of the rail frame.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide
89
Advertisement
Table of Contents
